When I push the start button u hear the motor trying to start and then goes dead.
I changed the belt worked for one cycle and then stoped
- Guest asked 9 years ago
Looks like that is the model number you attached with this question. It is the one provided to me. I looked up the new model number. I do not see a start relay like some units have or anything else that would cause that. You have eliminated the door switch, belt switch. Have you or are you able to by pass the start switch/button? You could be loosing a neutral some where. broken wire. The motors run winding could be bad as well. I have seen bad belt switches have this symptom, but you have already by passed it.
- Brian, Ace Appliance answered 9 years ago
- You must login to reply
Sounds like you have a bad motor. This is a typical symptom of a motor that goes bad. Just make sure that nothing is causing the drum to not turn freely or smoothly. Which it doesn’t sound like it since it did run through a cycle after you put the belt on. Typically when a dryer motor starts to fail it will start and run until it heats up and then it will shut off mid-cycle. Once it cools down it will start up again and run until it heats up again.
- Brian, Ace Appliance answered 9 years ago
-
bRIAN LISTEN i BY PASSED LID SWITCH, BELT SWITCH, TUB IS OUT OF THE UNIT, MOTOR RUNS WHEN I USED A ELECT CORD ONE PART TO NUMBER 2 ON THE START PUSH BUTTON AND THE OTHER END ON THE NUETRAL ON THE CORD AND PLUGED IT IN AND THE MOTOR RUNS. THE TIM ER I CHECKED BETWEEN B AND C WIRES AND ITS OKAY CONTINUITY, SO WHATS LEFT???
-
bRIAN THE MOTOR ONLY STARTS WHILE YOU HAVE THE START BUTTON DEPRESSED ONCE U LET OFF MOTOR QUITS.i UNDERSTAND ABOUT THE MOTOR GETTING HOT AND QUITTING BUT THIS IS NOT THE CASE HERE PLS CHECK IT OUT THANKS bRIAN
-
MODEL NUMBER IS DBSR453EB2WW IT IS NOT THE MODEL NUMBER YOU HAVW HERE THE AGQ8000FS2, WHWRE DID YOU GET THIS MODEL NUMBER.?
- You must login to reply
Please login first to submit.
