I have samsung diswasher shows heavy code. the diswasher continued to run, the drain pum keept running only way to turn the unit off is by turning the breaker off. any segestion
I cheked for debris inside the unit, I checked the imppeller no debris found. I took the bottom panel where leak sensor detection located no water found.t
- Guest asked 9 years ago
Hi. If just the heavy light is blinking, then this is a leakage error. I have attached the tech sheet on this unit for you. It explains this could be an issue with the main PCB or drain pump or leak sensor. It is hard to say what is causing a leakage error since you do not have any water leaking, which would be detected by the leak sensor on the bottom. I would try and run the unit through a test cycle in diagnostic mode. Refer to the service inspection mode in the tech sheet. I do not believe this unit will show any stored error codes. It would be nice to see if there are any other error codes. Let me know what you find and good luck!
- Brian, Ace Appliance answered 9 years ago
- You must login to reply
Please login first to submit.