whats wrong if display lights up and all buttons selected respond? but then you press start it does not come on
- Guest asked 7 years ago
- last edited 7 years ago
Hello
See complete diagnostics in the links below. ATry to enter unit into the diagnostic mode. If you cannot get the unit into the diagnostic mode unlug it it for 5- minutes to reset the board.
DIAGNOSTIC TEST MODE
1) Be sure the washer is in standby mode (plugged inwith all indicators off; or with only the ClothesClean or Done indicator on).
2.Select any one button (except POWER, START,STOP and PAUSE/CANCEL) and follow the stepsbelow, using the same button (remember thebutton):
a.Press/hold 3 seconds.
b.Release for 3 seconds.
c.Press/hold 3 seconds.
d.Release for 3 seconds.
e.Press/hold 3 seconds.➔If this test mode has been entered successfully,all indicators on the console are illuminated for5 seconds with88showing in the EstimatedTime Remaining two-digit display.➔If indicators do not display as described above,the press/hold/release procedure above may nothave been performed within the time framenecessary for successful entry. Repeat step 2 toensure this was not the cause. If stillunsuccessful, see Diagnostic: UnsuccessfulEntry, page 1.3.The program then checks for saved fault codes:➔If there are saved fault codes, see Diagnostic:Saved Fault Codes.
- AV Repair Help answered 7 years ago
- You must login to reply
Please login first to submit.