No error codes or flashing lights. water seems to get hot.
I have continuity with element, how do I test temp sensor(not thermistor) for resistance? Could it be turbo sensor?
- Guest asked 9 years ago
Hi. I have attached the tech sheet for you unit. This should should be for your unit. The model number you provided was not valid. Please recheck your model number. In the tech sheet it explains how to enter into service mode and check for any stored error codes. This is the first thing I would do. IS the unit getting enough water? The tech sheet also has the temperature sensor resistance chart. It shows the test points from the control board to test the temp. sensor. Let me know if you need any further assistance.
- Brian, Ace Appliance answered 9 years ago
-
Thanks Brian, Unfortunately the last to pages with board and all are very blurry and cannot read most of it. Can you tell me from the picture were to put my leads or not? Thanks. also can I acces tech sheets from most manufacturer sites?
-
“Last Two Pages” are blurry.
-
It looks like pin 9 and 10 of the cn001 connector is for the sensor. Unplug the connector and then check these pins/wires at the harness. At room temp you should have about 55 k ohms.
- You must login to reply
Please login first to submit.