The complaint is that the dishes are not drying. I have no tech sheet and am looking for a way to run a diagnostic test or jump through the sequence so I don’t have to sit and wait for the element to turn on. The element does have continuity and 12.2 ohms. Thanks, Andy
Tested voltage – ok, tested element – ok, tested thermostat- ok
- Guest asked 7 years ago
- last edited 7 years ago
Hello
There are a few possibilities for the dishes not drying.
1) Control programmed to disable heater, but continue running cycles, if it detects a water heating problem.
2) Heater circuit problem: – Open in heater. – Open connection or component in Heater circuit.
3) Heater Drive circuit on the control.
For all three issues go to page #9 in the technician manual link below. This will walk you through each issue step by step.
Matt Ace technician
- AV Repair Help answered 7 years ago
- You must login to reply
Please login first to submit.
