Inspected device burner has Cottonwood.
Unplug the device let set for two minutes plugged in code went away but reappeared next day when customers using code appears when lower burner is activated in oven not one upper burger is being used
What you can offer in recommendation as to how to solve problem
- Guest asked 7 years ago
- last edited 7 years ago
Hello
See the complete technician link below . Matt Ace technician
The F3E2 error is a few possibilities :
1) Oven sensor opened
2) Oven sensor shorted
3) BAKE/BROIL range over temperature CLEAN range over temperature.
Diagnostic procedure
1) Press CANCEL>CANCEL>START to enter the Diagnostics Mode. Verify the sensor
temperature reading is at room temperature (typically 50 to 90°F [10 to 32.2°C]) and verify
failure code. If failure code does match, then continue.
2. Unplug range or disconnect power.
3. Check all sensor connections on harness and board.
4. Disconnect sensor from harness.
5. Measure sensor resistance between connector pins and confirm reading is between
1000Ω and 1200Ω at room temperature. Also measure from sensor connector to sensor
casing for possible short. If measurement is not correct, or if short is found, replace
sensor.
6. Trace wires and connectors to sensor from control, then back to control. If wire or
connection is damaged, replace the harness. If wire or connector is not damaged,
replace oven temperature sensor.
7. Reconnect the sensor to the harness.
8. Replace all parts and panels before operating.
9. Plug in range or reconnect power.
10. Press CANCEL>CANCEL>START to enter the Diagnostics Mode and clear the error
code.
11. Press CANCEL to cancel the Diagnostics Mode.
12. Press BAKE and START. Observe for longer than 1 minute.
13. If failure does not reappear, stop. If failure remains, unplug range or disconnect power and check wire connections.
- AV Repair Help answered 7 years ago
- You must login to reply
Please login first to submit.
