Can't get the tub to come out

Hi. The model number you have listed is not valid. It looks like the last 2 digits are off. I have looked up similar model numbers. It looks like you have a Whirlpool Cabrio or Maytag Bravos style top load washer. I’m not sure how far into the repair you are. Once you lift up the top panel/lid of the washer you then have to remove the tub ring by releasing the tabs. Then remove the cap of the impeller and remove the bolt of the impeller and remove the impeller, just like in the video. Now you are ready to pull the tub out which can be difficult to do sometimes. If may require two people. In fact two people will make this task a lot easier. The tubs on these washers can be very difficult to remove as they get “stuck” on the shaft and when you try and pull just the basket up the whole tub assembly comes up with it. You can also try to wiggle the basket back and forth as you pull up on it to try and free it from the shaft. One person needs to grab the basket on each side of the lip inside and pull up evenly and straight off the shaft while the other person holds the outer tub down so it doesn’t move up with the basket when you pull it. This may take a lot of upward force to pull the basket off the shaft. I hoped this has helped and good luck with your repair. Please let me know if I can be of further assistance.

Tech Brian V