You can select a cycle the machine wil take all camandes but when you push the start button all it does is beep 3 times and does noting. I put it into the diagnostic check and it will go throu it ok and all things work. As soon as you select a wash cycle it just beeps 3 times and just sets there. No fault codes come up on display I checked old codes on machine the only one was a long drain so I cleaned out filter. Stil just 3 beeps no wash. Any help would be appreciated .
- Guest asked 9 years ago
Does the door lock in the diagnostic mode? Check your door latch/ door switch. It sounds like it is acting as if the door is open. There is a switch on this latch that pushes in when the door is closed. This could be your issue. Attached is a link to the part with a picture.
- Brian, Ace Appliance answered 9 years ago
-
Yes it does lock. I pushed that part of the switch a couple of times before I started the diagnostics. Once I opened the door it didn’t work. When I put it into the diagnostic mode it did beep 3 times but it locked the door and went into diagnostics. No fault codes came up at end of diagnostics.
-
That is very odd. We do not have a good place to start with out it giving us an error code. It is also running through the test cycle just fine. Make sure you have proper power and ground to the unit and the back and front panels are on. There are ground switches under the panels that need to be pressed in.
- You must login to reply
Please login first to submit.
