The initial complaint was that the refrigerator is freezing everything so when I showed up there thermistor and everything seem to be OK just a little bit enclosed in snow so I cleaned everything out make sure that leads are good and not shorting and try to reset the fridge but after me full and around with it it started flashing the temperature bars in sequence from left to right. Not sure what’s going on here seems like it’s in program mode but I didn’t put it into program mode all I did was clean the condenser plug everything back in and turn the fridge back on and leave. I figured the flashing would stop I’ve gotten it before when the door was open for too long.. Any suggestions on what I can do to reset the fridge to proper running order at least to over freezing like it was before I got there hah
THE DIAGNOSTIC GUIDE INSIDE ISNT VERY HELPFULL IT CATERS TO BOTH FREEZER AMD REFRIGERATOR VERSION OF THIS UNIT FOR THE MOST PART
- Guest asked 7 years ago
Hi. I have attached the service manual on a similar unit. Take a look at page 6. This might be the power up alarm and you will need to press the alarm off button. Or you may have hit the switch for the showroom mode. This switch is in the condenser compartment near the power switch it looks like. You may have hit this switch when you were cleaning the condenser.
- Brian, Ace Appliance answered 7 years ago
-
I tried turning it on with the show room switch in either direction suspecting that that’s what I touched but neither of them made a difference and it seems like a sequential flash from left to right and then all of them flash at once and then it goes back to the sequential and back-and-forth
-
That’s strange. I would look through the service manual and see if you can find anything that references those lights flashing in that sequence. I did not find any information for that sequence the lights are flashing in.
- You must login to reply
Please login first to submit.
