You said last week about the water temp going below 59 degrees it will try to take on hot water to bring temp up. This washer is in the county jail. They are not allowed to have hot water to wash. Is there some way around this so it won’t go to default. And do you have to erase the old codes before the machine will work. I replaced pressure switch.
- Guest asked 9 years ago
- last edited 9 years ago
I don’t see where we talked about the temp of the water in the question from last week. Some washers will require a certain temp of water even though it is set to cold wash. I do not see the thermistor on this unit but there may be one. The error code from what I recall does not talk about a water temp either. You can make sure they are only using cold washes, or hook up a inlet hose splitter so that you can have cold water going to both the hot and cold at the back of the washer. Then it will fill if they select a warm or hot wash. If you still get an error there is not much you can do. You can’t bypass the thermistor or disconnect it or you will still get an error code. The control is programmed to read the thermistor so it would still give you trouble anyway you try to get around it.
- Brian, Ace Appliance answered 9 years ago
- last edited 9 years ago
- You must login to reply
Please login first to submit.