I’ve got an error code E08,03 – short circuit coil, wiring to coil or controller, replace controller
The water seems to be entering the tub okay when I put it into diagnostics, however when I tried to put it into a short cycle diagnostics mode, the dishwasher wouldn’t enter into this diagnostics mode. I’m suspecting a bad control board.
- Georgia Steeler asked 2 years ago
- last active 2 years ago
- Guest asked 5 years ago
- last active 5 years ago
Checked internals-Pretty clean
Checked heater-seemed fine
Checked both thermostats on the heater-seemed to be fine but couldnt test when they open
Everything else in the dryer seemed to be ok, the dryer element was cycling off and on throughout the cycle and i know one thermostat cut off is 115 Celsius which when it ran i did notice the dryer was about 200f inside which is on par with that thermostat but there is another thermostat with a lower rating which didnt seem to affect it. Let me know what yall think. Dont really need any diagrams just someone more experienced then me opinion.
- Guest asked 6 years ago
- last active 6 years ago
I purchased a Fisher & Paykel fridge some years ago and now the handle on the fridge has broken off. The top of the handle is a hook that goes into the door and the bottom looks like it had a lug into the door that has sheared.
- Fred Abernethy asked 6 years ago
- last active 6 years ago
I get a lid lock error in diagnostics mode. However it stopped mid cycle. I did replace the lid lock, still no function. just beeping. I ordered the sensor control board but before I install it would like to know if it could be something else
- Guest asked 6 years ago
- last active 6 years ago
HOW DO I TROUBLESHOOT THIS? I SUSPECT BAD WATER VALVE. NO WATER IN TUB AND COMING UP WITH U6 ERROR CODE. THANKS.
- mdhomeservices asked 6 years ago
- last active 6 years ago
When i open the fridge door it beeps and flashes. Fisher and Paykel Fridge.
- Guest asked 7 years ago
- last active 7 years ago
Motor will not run, lights come on but will not start, electrical burning smell.
- David Sutton asked 7 years ago
- last active 7 years ago
Fault code is displayed, will not run, will not heat, display will not light up.
- James Buchanan asked 7 years ago
- last active 7 years ago
Drum bounces around, grinding sounds while running.
- Harley Clark asked 7 years ago
- last active 7 years ago
Garments are still wet at end of cycle, cycle will not end, burning smell.
- David Sutton asked 7 years ago
- last active 7 years ago
Motor will not run, lights come on but will not start.
- Hall Refrigeration asked 7 years ago
- last active 7 years ago
Steam cycle will not work, garments are not refreshed.
- Curtis Appliance Repair asked 7 years ago
- last active 7 years ago
Steam cycle will not work, garments are not refreshed.
- Patrick's Appliance Service asked 7 years ago
- last active 7 years ago
Clothes come out wet, light comes on but will not run.
- Curtis Appliance Repair asked 7 years ago
- last active 7 years ago
unit will not stop running, dryer shuts off too soon, front panel is hot to the touch.
- James Buchanan asked 7 years ago
- last active 7 years ago
Clothes are getting torn, laundry ends up in a balled up or knotted the end of cycle.
- Harley Clark asked 7 years ago
- last active 7 years ago
sticker is pealing off, settings are unreadable, console is loose.
- Fred Abernethy asked 7 years ago
- last active 7 years ago
Display is blank, no voltage to the motor, error codes are displayed, Fault code 151.
- David Sutton asked 7 years ago
- last active 7 years ago
Unit beeps then Error codes are displayed, display is blank, powers up but will not run, Fault code 151.
- Harley Clark asked 7 years ago
- last active 7 years ago
Trouble pulling the doors out, Clicking or scraping sound when opening the drawers.
- Don Kopecky asked 7 years ago
- last active 7 years ago
Frozen food being softer due to insufficient cooling, Temperatures in freezer 10-15 degrees Fahrenheit warmer.
- Patrick's Appliance Service asked 7 years ago
- last active 7 years ago
Noise from fan blade striking objects around it.
- James Buchanan asked 7 years ago
- last active 7 years ago
Difficult to move, Wheels making scraping sound when moved.
- David Sutton asked 7 years ago
- last active 7 years ago
Compressor will receive too much power and burn out.
- Harley Clark asked 7 years ago
- last active 7 years ago
Not cooling, Other functions will not operate.
- Curtis Appliance Repair asked 7 years ago
- last active 7 years ago
No water to Ice Maker, Water may not dispense.
- David Sutton asked 7 years ago
- last active 7 years ago
Not cold inside, No airflow through vents, High pitched squealing sound.
- Harley Clark asked 7 years ago
- last active 7 years ago
Cannot change settings, Unit will not cool, Unit has no power, Unit will not stop running.
- T&G Appliance Repair asked 7 years ago
- last active 7 years ago