-
the basket and spider are okay. I’ve checked them the basket is round I’ve turned it and tried moving the basket, bearings are good.spider arms are good. What and where is the sensor that determines whether the basket is out of balance. and how do you test it, I’m considering replace whatever sensor is along with control board Joe
-
also this cycle repeats it self continuously. over night if you let it Joe
-
also in service mode spin cycle test basket shake at about 300 rpm, then smooth out and goes 1600 – 1700 rpm very smoothly, shaking at 300 rpm in when the balance ring self balances.
-
Gottcha. So, if this is happening with out a load and everything checked out as you said it did it must not be an off balance issue. Did you say the cycle goes through and then gets stuck in spin? Will it just stay stuck in spin with the drum rotating overnight or does it start a new cycle, or spin while it says the unit is done? How many minutes left does it stick at? Sounds like you may have a faulty control. I would double check your error codes to see if any new show up and if any that are listed in the tech manual show up.
-
sample no load; put in spin only cycle, starts at 10 minutes, goes yo 8 minutes pauses chimes, goes back to 10 minutes. gets down to 8 minuted, chimes stops pauses, goes back to 10 minutes repeats for hours.
-
That’s a strange one. Can’t say that I have seen this issue before. Only with off balance issues but they never ran that long.its going to be hard to diagnose this issue, especially with no error codes to go off of. Seems like a control board issue to me. Will a wash cycle run through normally until its gets to the rinse cycle or spin cycle?
